Renfort de zones de parkings recouvertes de gazon TENAX GP FLEX

Stabilizing net for green traffic areas

Data sheet

chiodi a U per il fissaggio

Accessoires
30 cm U staples

TENAX GP FLEX

Renfort des espaces verts
Filet extrudé produit en polyéthylène haute densité avec une structure tri-dimensionnelle idéale pour renfort de zones de parkings recouvertes de gazon et de routes ou de gazons utilisés par un grand nombre de piétons - même ceux sur des fondations peu solides - pour des utilisations permanentes ou temporaires, par exemple:

APPLICATIONS
	Spectacles et concerts
	Garages et zones pour camions et parkings pour caravanes
	Chemins recouverts de gazon
	Zones piétonnes
	Toute surface dont la zone engazonnée risque d’être endommagée ou sujette à la formation d’ornières
	Stabilisation de chemins de terre
	Cours ou parkings

AVANTAGES
	Protection des espaces verts
	Facile à installer
	Recyclable
	Excellent impact esthétique

Alternatively, the grass can be sown by simply laying the TENAX FVP Prato Carrabile before installing the net.

Code	Dimensions m	Couleur	Poids	UV	UV/ pallet
1A090471	2.00x20	gr/brw	1800	roll	4
1A090470	2.00x20	gr/brw	1400	roll	4

The details supplied herein are provided for information purposes only and are based on experience acquired by TENAX with regards to products and their applications. TENAX will therefore not be held responsible for any inaccuracies. Information and suggestions provided are subject to change in the event of modifications to test and/or production procedures.

INSTALLATION

1) We recommend excavating to a minimum of 30 cm. If the presence of clay soil, an adequate draining system must be installed to avoid standing water.

2) Carefully level the laying surface. If filling earth has been laid, compress the laying surface with compactor rollers until obtaining compaction equal to 95% of the Proctor Standard.

3) Spread sandy subsoil (a mixture of cultivation soil and sand) with a thickness of 2 cm at least. Carry out an initial sowing of the substrate.

4) Unroll TENAX GP FLEX and fix one end of the roll and its sides at intervals of 1 m with TENAX “U” pins (30 cm in length), being careful to place the rolls next to each other (fig. A). The length of the pins will depend on the consistency of the subsoil. The net must also be fixed in areas where its distance from the surface is deemed excessive; fixing must be carried so as the net has tension when installed, in order to avoid the formation of creases and to ensure adequate adherence to the laying surface.

5) Fill the TENAX GP FLEX mesh with sandy and dry soil, entirely covering the net, but the layer of soil must be minimal in order to allow the re growth of roots around the net mesh.

6) Carry out sowing, roll and dampen with the same frequency and methods as used with normal grass. We recommend the use of a Gramineae mixture suitable to be trodden on.

7) For obtaining the best results we suggest that vehicles do not use the reinforced grass until it has grown to at least 35 mm and has been cut twice.